SwitchBot Wall Light Switch Mounting Base

SwitchBot Fingerbot Wall Light Switch Mount Base

◆Product Overview
This is a mount base specifically for the SwitchBot Fingerbot, compatible with Panasonic Cosmo Series Wide 21 (120 x 70mm) switches.
It can be attached to a single vertical switch (1-gang) or the center switch of a vertical 3-gang switch.

☆☆Attention☆☆
This product is designed based on Panasonic Cosmo Series Wide 21 switch plates. It is not compatible with square types (see photos). Please be careful not to make a mistake when purchasing.

◆Product Contents (May be shipped assembled)
Base x 1
Mount x 1
*SwitchBot unit is not included.

◆Material
PETG Resin (White)
*Not resistant to high temperatures (above 40°C), so please use indoors.

◆Installation Method
1. Combine and join the base and mount parts. (The parts are designed to snap together.)
2. Attach the SwitchBot unit to the mount.
3. Snap the base onto the switch plate. *The size is designed to be slightly tight for a secure fit.

【Notes】
- All products are shipped after a functional check. During operation, the part holding the SwitchBot may move slightly; this is a design specification. If there are any operational issues, please contact us via comment before leaving a review. We will respond promptly and sincerely.
- Due to the nature of 3D printing, there will be layer lines.
- There may be sanding marks on the surface.
- Please refrain from purchasing if you are looking for a perfect finish or are concerned about minor details.
- Product photos are stock photos. Thank you for your understanding.